mercstuff.com

 

Lower Bearing Carrier Assemblies

Click Here For Prices

Click here for carrier removal instructions

 

    1965 - 1970 Pre-Alpha
         Lower Carrier

This is MerCruiser p/n 52835A2. It is used on Pre-Alpha drives made from approximately 1965 - 1970.

 

It includes :

(1) Rear needle bearings ( installed )
(2) Standard propeller shaft seals ( installed )
(1) 4 3/8 locking tab washer ( shown below )
(1) 4 3/8 carrier nut ( shown below )

 

 

 

 

 

The total over all length of this carrier is 4 1/2 inches long.

 

This Carrier comes from MerCruiser.

Shipping Wt. 2 1/2 Lbs.

 

    : Order # 2835

 

 

 

 

 

 

           1971 - Date
   Pre-Alpha & Alpha
       Lower Carrier

This is MerCruiser p/n 818763A10 ( old #'s 73020A14, 73020A20 &  818763A4 ). It will fit all Pre-Alpha, Alpha One and Alpha One/Generation II drives made from approximately 1971 - Date.

It includes :

(1) Rear needle bearings ( installed )
(1) Standard propeller shaft seal ( installed )
(1) Fishline cutter propeller shaft seal ( installed )
(1) Round zinc anode
(1) 3 7/8 o-ring
(1) Stainless steel key
(2) Stainless steel screws and lock washers

 

 

 

 

 

The total over all length of this carrier is 5 1/2 inches long.

 

This Carrier comes from GLM Marine.

Shipping Wt. 3 1/2 Lbs.

    : Order # 1405

 

 

 

      1988 - Date Bravo 1
          Lower Carrier

This is MerCruiser p/n 41641A8 lower carrier. It will fit standard Bravo 1 lower units made from 1988 to Date.

It will not fit Bravo 1 XR, XZ, Bravo 2 or Bravo 3 drives.

It includes :

(2) Standard propeller shaft seals ( installed )
(1) Outdrive oil drain plug ( installed )
(1) Round zinc anode
(1) 3 7/8 o-ring
(1) Thrust washer ( .105 thick )
(1) Load ( or crush ) ring
(2) Stainless steel screws and lock washers

The total over all length of this carrier is 4 5/8 inches long.

This Carrier comes from Quicksilver.

Shipping Wt. 3 1/2 Lbs.

    : Order # 1641

 

 

     1973 - 1993 TRS
     Lower Carrier

This is MerCruiser p/n 66663A1 lower carrier. It will fit 1973 - 1993 TRS lower units.

It includes :

(1) Rear needle bearings ( installed )
(2) Standard propeller shaft seals
      ( installed )

The total over all length of this carrier is
7 inches long.

This Carrier comes from Quicksilver.

Shipping Wt. 3 1/2 Lbs.

    : Order # 6663

 

 

Contact Us                    Home Page


        

Precision Services, Inc.
Shelby Township, Michigan   48316

Monday - Friday 9:00AM - 5:00PM EST
 

  Last modified: May 09, 2008 

Copyright ©  2001-2005  Precision Services, Inc. · All Rights Reserved