Gimbal Housing Seals
Click
Here For Prices
PLEASE NOTE ! ALL OF THE SEALS BELOW FIT IN-BETWEEN THE BACK OF THE GIMBAL
HOUSING AND THE FIBERGLASS ON THE BACK OF THE BOAT. TO USE ANY OF THE SEALS
BELOW, THE ENGINE MUST BE REMOVED FROM THE BOAT TO INSTALL ANY OF THESE SEALS.
IF
YOU'RE LOOKING FOR THE BELL HOUSING GASKET KIT TO PUT THE OUTDRIVE BACK ON TO
THE BOAT, CLICK HERE.
These
2 seals were used from approximately 1967 to 1976.
The
only difference is the distance at the bottom of the seal.
Gasket
# 5373 Fits:
1970-1977
120/140/165
1974 225-S
1975-1977 233
1971-1977 888
Click
here for outdrive mounting kits.
This
seal is approximately 1/2" diameter and about 44 inches long. It fits into
grove cut in the backside of the gimbal housing.
For
1977 to 1991 Pre-Alpha and Alpha
: Order # 5533
For
1988 to Date Gen II and all Bravos
: Order # 3713
Click
Here to see where these seals fit.
Click
here for outdrive mounting kits.
TR/TRS
Transom Gasket
This is
MerCruiser part # 27-54395T Cork Transom Gasket.
Click
here for outdrive mounting kits.
:
Order # 5439
Click
Here For Prices
MerCstuff,
llc 
